Anonymous
My feedback
18 results found
-
12 votesAnonymous supported this idea ·
-
14 votes
Thanks for the idea!
We are reviewing this idea for future programming.
Anonymous supported this idea · -
24 votes
Thanks for the idea!
Anonymous supported this idea · -
18 votes
Thanks for the feedback!
We will look into this for future development!
Anonymous supported this idea · -
6 votes
Thank you for bringing this to our attention!
We are researching this issue and will work on a correction!
Normally, any issues should be verified through Technical Support, but due to the simple nature of this, we can verify and correct it without a ticket.
An error occurred while saving the comment Anonymous shared this idea · -
10 votes
Thanks for the idea!
We will be reviewing this feature for possible future development.
Anonymous supported this idea · -
10 votesAnonymous supported this idea ·
-
22 votesAnonymous supported this idea ·
-
40 votesAnonymous supported this idea ·
-
3 votes
Thanks for the idea!
We are reviewing this for future programming! Be sure to watch for this in future releases!
Anonymous supported this idea ·Anonymous shared this idea · -
7 votes
Thanks for the feedback!
We are currently reviewing this feature for future programming.
Anonymous supported this idea ·An error occurred while saving the comment Anonymous commentedWhen ordering R&D parts for our company (small quantities that may not become a real inventory item) it is easy to make costly typo errors. I recently wanted to order part number:
BZX84C12LT1OSTR on my vendor's website.
Instead, I ordered BZX84C12LT10STR.If I had been able to copy from vendor's website and paste into my purchase order (as I did for years with CMS Pro) it would not have resulted in additional phone calls and another day delay in receiving a needed part. Many times my Engineers will give me a spreadsheet with the part numbers, but I still can't paste them into the PO.
I now spend hours typing these long complicated part numbers and having a second person double check all my typing. If we could copy and paste part numbers into the PO line items it would only takes minutes to order 20 to 50 new part numbers like the example above without errors.
Anonymous shared this idea · -
14 votes
We are reviewing this feature for future development.
Anonymous supported this idea · -
20 votes
Thanks again for your suggestions. I’ll send this over to development for review.
Anonymous supported this idea · -
28 votesAnonymous supported this idea ·
-
34 votes
Thanks for the idea!
This is being reviewed for future programming. Watch for further updates in the future.
Anonymous supported this idea · -
78 votes
This idea has been submitted for future development.
Anonymous supported this idea · -
8 votes
This has not been started at this point. We are looking into it and putting it in our list of things to.
Anonymous supported this idea · -
74 votesAnonymous supported this idea ·
Inventory Component Requirement Report:
010-6000 3464 Keystone Spacer <<< Wrong
IN Understock Report:
010-6000 Spacer 0.25 x 0.25 x 0.125 hole <<< Correct